Features:

  High performance RISC CPU.

o   ONLY 35 simple word instructions.

o   All single cycle instructions except for program branches which are two cycles.

o   Operating speed: clock input (200MHz), instruction cycle (200nS).

o   Up to 368×8bit of RAM (data memory), 256×8 of EEPROM (data memory), 8k×14 of flash memory.

o   Pin out compatible to PIC 16C74B, PIC 16C76, PIC 16C77.

o   Eight level deep hardware stack.

o   Interrupt capability (up to 14 sources).

o   Different types of addressing modes (direct, Indirect, relative addressing modes).

o   Power on Reset (POR).

o   Power-Up Timer (PWRT) and oscillator start-up timer.

o   Low power- high speed CMOS flash/EEPROM.

o   Fully static design.

o   Wide operating voltage range (2.0 – 5.56)volts.

o   High sink/source current (25mA).

o   Commercial, industrial and extended temperature ranges.

o   Low power consumption (<0.6mA typical @3v-4MHz, 20µA typical @3v-32MHz and <1 A typical standby).

Peripheral Features

o   Timer 0: 8 bit timer/counter with pre-scalar.

o   Timer 1:16 bit timer/counter with pre-scalar.

o   Timer 2: 8 bit timer/counter with 8 bit period registers with pre-scalar and post-scalar.

o   Two Capture (16bit/12.5nS), Compare (16 bit/200nS), Pulse Width Modules (10bit).

o   10bit multi-channel A/D converter

o   Synchronous Serial Port (SSP) with SPI (master code) and I2C (master/slave).

o   Universal Synchronous Asynchronous Receiver Transmitter (USART) with 9 bit address detection.

o   Parallel Slave Port (PSP) 8 bit wide with external RD, WR and CS controls (40/46pin).

o   Brown Out circuitry for Brown-Out Reset (BOR).

Key Features

o   Maximum operating frequency is 20MHz.

o   Flash program memory (14 bit words), 8KB.

o   Data memory (bytes) is 368.

o   EEPROM data memory (bytes) is 256.

o   5 input/output ports.

o   3 timers.

o   2 CCP modules.

o   2 serial communication ports (MSSP, USART).

o   PSP parallel communication port

o   10bit A/D module (8 channels)

Analog Features

o   10bit, up to 8 channel A/D converter.

o   Brown Out Reset function.

o   Analog comparator module.

Special Features

o   100000 times erase/write cycle enhanced memory.

o   1000000 times erase/write cycle data EEPROM memory.

o   Self programmable under software control.

o   In-circuit serial programming and in-circuit debugging capability.

o   Single 5V,DC supply for circuit serial programming

o   WDT with its own RC oscillator for reliable operation.

o   Programmable code protection.

o   Power saving sleep modes.

o   Selectable oscillator options.